利用含砷氧化锌尘制备活性氧化锌

用NH3-（NH4）2SO4溶液浸取处理含砷氧化锌尘,可彻底清除砷,制备出合格的活性氧化锌。对于含砷质量分类为1%-2%的原料,产品中所含砷质量分数可降至0.0005%以下。该方法具有除砷彻底,不易产生二次污染的优点,为含砷氧化锌尘的综合利用提供了一种新方法。     

An estimate of the contribution of outdoor concrete yards used by livestock to the UK inventories of ammonia, nitrous oxide and methane

Many farms have unroofed concrete yards used by livestock. These concrete yards have received little attention as sources of gaseous emissions. From 1997 to 1999 measurements were made of emissions of ammonia (NH₃), nitrous oxide (N₂O) and methane (CH₄) from 11 concrete yards used by livestock. A postal survey was carried out to assess the areas of yards on farms in England and Wales to enable the measurements to be scaled up to estimate national emissions. Using the results of this study NH₃-N emissions from farm concrete yards were calculated to be ca. 35×10³ t annually. This is 13% of the current estimated total NH₃-N emission from UK livestock. Concrete yards were an insignificant source of N₂O and CH₄ which were both <0.01% of current estimates of agricultural emissions.     

催化脱除氮氧化物研究进展

消除氮氧化物污染是环境保护中的一项重要课题。催化脱除氮氧化物一直是人们解决上述课题应用的主要方法。本文对催化脱除法中应用的各种催化剂的研究进展状况作一回顾和总结     

复合氧化物催化剂用于汽车尾气净化的研究

研制了一系列非贵金属复合氧化物催化剂,测定这些催化剂净化汽车尾气的活性和抗硫、磷、铅及析碳中毒等性能,排出了它们的活性和抗硫中毒的顺序。实验表明,ASC(Re-Mn-Pb-Cu-Cr-A-O_x/Al_2O_3,A助剂)催化剂具有较高的活性及较好的抗硫磷、铅及析碳中毒性能,具有较好的应用前景。     

g-C3N4/Cu2O/CF电极制备及在微生物燃料电池中的应用

为了提高微生物燃料电池的产电性能,采用电沉积法将石墨态氮化碳(g-C_3N_4)与氧化亚铜(Cu_2O)负载到碳毡(Carbon felt,CF)表面,制得g-C_3N_4/Cu_2O/CF光电极用于构建微生物燃料电池.通过场发射扫描电子显微镜(SEM)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、傅里叶变换红外光谱(FT-IR)、光生电流曲线(I-T)、线性扫描伏安曲线(LSV)对光电阴极进行光电性能测试,并在白光发光二极管(LED)辐照下研究了以Cu_2O/CF、g-C_3N_4/Cu_2O/CF为阴极光催化微生物燃料电池的产电性能.结果表明,g-C_3N_4/Cu_2O/CF电极中g-C_3N_4分布在Cu_2O之间;g-C_3N_4/Cu_2O/CF光电极能提高光利用率,与Cu_2O/CF光电极相比,光电流密度达到2700 mA·m~(-2),增长幅度达到125%;与Cu_2O/CF阴极微生物燃料电池相比,g-C_3N_4/Cu_2O/CF阴极微生物燃料电池具有更优的产电能力,在白光LED辐照下最大功率密度和光电流密度达到110.7 mW·m~(-2)和1102 mA·m~(-2),增长幅度达到16%和27%.     

Investigating the phenol removal from aqueous media by photocatalytic magnetized graphene oxide nanocomposite

As a large and diverse group of secondary metabolites, phenolic compounds are one of the most common chemical pollutants present in water resources. these compounds can have toxic effects on ecosystems and humans. Therefore, their removal from water sources appears to be of great importance. In this study, a magnetic graphene oxide (MGO) photocatalyst was synthesized and used to remove phenol from water. The fabricated GO magnetic nanocomposites were determined by SEM and FTIR techniques. Afterward, these nanoparticles were used to remove phenol from aquatic media considering different operational parameters, including pH of the solution, initial concentration of phenol, contact time, and adsorbent dosage. The results showed that the magnetized GO nanoparticles could remove 90.83% of phenol molecules under the optimal conditions of solution pH = 3.0, initial phenol concentration of 20 mg/L, adsorbent concentration of 300 mg/L, and contact time of 120 min. additionally have compared the results of UV, Fe₃O₄/GO, and Fe₃O₄/GO/UV on the removal of phenol under optimum conditions. Accordingly, the phenol removal efficiencies for UV alone, Fe₃O₄/GO, and Fe₃O₄/GO/UV were obtained at 4.5, 65.73, and 90.83%, respectively. Based on the findings, the prepared magnetic GO nanoparticles have extended capabilities such as easy and rapid separation from sample and high potential in removing phenolic compounds, so, it can be introduced as an appropriate adsorbent for removal of this pollutant from water and wastewater.     

三亚河水体中甲烷和氧化亚氮的分布、释放及影响因素研究

甲烷(CH₄)和氧化亚氮(N₂O)是大气中重要的温室气体,对全球变暖和大气化学有重要作用。受人为活动影响较大的河流、河口是大气中CH₄和N₂O的重要源。于2019年春季、2020年秋季台风前后沿三亚河从下游到上游采集了11个站位的样品,测定三亚河水体中CH₄、N₂O浓度及相关参数,并估算了水-气界面释放通量。结果表明：春季、秋季以及台风后CH₄平均浓度分别为(15.92±23.04)、(364.43±265.41)、(666.02±502.60) nmol/L,N₂O平均浓度分别为(24.37±19.88)、(8.47±5.19)、(47.48±33.47) nmol/L,台风后大于台风前。水体中CH₄、N₂O主要受溶解氧(DO)和降雨影响,下游河段主要受潮汐作用影响。现场产生和沉积物释放是水体中CH₄的主要源,硝化作用是水体中N₂     

外源NO对Cu胁迫下番茄幼苗L-精氨酸代谢的影响

一氧化氮(nitric oxide,NO)作为生物活性分子,广泛参与各种生物和非生物胁迫。采用营养液培养,研究Cu胁迫下番茄体内L-精氨酸、NO、多胺代谢对外源NO的响应机制,以期为铜污染区域蔬菜种植提供科学依据和技术支持。结果表明,Cu胁迫下添加外源SNP(硝普钠,外源NO供体)能够调节番茄根系和叶片中精氨酸脱羧酶(Arginine Decarboxylase,ADC)、鸟氨酸脱羧酶(Ornithine Decarboxylase,ODC)及一氧化氮合酶(Nitric Oxide Synthase,NOS)活性。根系中,外源SNP能够上调NOS活性,L-精氨酸代谢向着NO合成方向进行;叶片中,外源SNP能够同时上调ADC、ODC、NOS活性,PA、NO的合成同时进行;此外,Cu胁迫下添加外源SNP能够增加根系和叶片L-精氨酸含量,而作为PA、NO的合成前体,精氨酸含量升高无疑会间接促进PA、NO的合成,从而提高番茄对Cu胁迫的抵抗能力。     

纳米钙钛矿型LaMnO3的制备与汽车尾气处理

用PEG法制备了钙钛矿LaMnO3纳米材料,并将其负载在涂有γ－Al2O3的堇青石载体上作为净化尾气的催化剂。用XRD、TEM对产物的结构及表面性能进行了分析。在依维柯汽车上进行了怠速、正常行驶及倒拖时催化剂三效性能的测试。发现纳米晶活性组分的催化效率比溶液浸渍法制得的催化剂好。     

不锈钢酸洗过程中NOx的产生机制及控制

为降低奥氏体不锈钢混酸(HNO_3+HF)酸洗过程中产生的NO_x量,利用自制的酸洗-吸收装置研究了HNO_3和HF质量浓度及抑制剂和促进剂加入量对NO_x生成量的影响,探讨了NO_x的产生机制。结果表明,奥氏体不锈钢酸洗的优化工艺条件为:酸洗温度20～50℃,HNO_3质量浓度90～110 g/L,HF质量浓度40 g/L,抑制剂加入量30 g/L,促进剂加入量1～2 g/L。抑制剂的加入降低了NO_x的生成量,促进剂的加入减少了氧化皮酸洗时间,提高了酸洗效率。酸洗产生的NO_x来源于两部分:一是氧化皮与酸洗液反应,约占NO_x生成量的70%,二是裸露基体与酸洗液反应,约占NO_x生成量的30%。